(1) Welders should never carry or use butane lighters while welding! A spark from a welding arc can land on the lighter, burn through and expose the fluid in the lighter, causing an explosion. There is the same amount of force in a disposable butane lighter when it explodes as there is in approximately 3 sticks of dynamite!
(2) Always wear protective clothing suitable for welding.
(3) Always wear proper eye & ear protection when welding, grinding, or cutting.
(4) Keep your work area clean and free from hazards.
(5) Handle all compressed gas cylinders with extreme care. Keep caps on when not in use.
(6) When it is necessary to arc weld in a damp or wet area, wear rubber boots and stand on a dry insulated platform.
(7) Shield others from the light rays produced by your welding arc.
(8) Do not weld on sealed containers or compartments without providing vents and taking special precautions.
(9) Do not weld on containers that have held combustibles without taking extra special precautions.
(10) If it is necessary to splice lengths of welding cable together, make sure all electrical connections are tight and insulated. Do not use cables with frayed, cracked or bare spots in the insulation.
(11) Do not weld in a confined space without extra special precautions.
(12) When compressed gas cylinders are empty, close the valve and mark the cylinder "MT".
(13) Do not allow flame cut sparks to hit hoses, regulators or cylinders. Remember flame cutting sparks can travel 30-40 feet.
(14) Never use acetylene at a pressure in excess of 15 psi. Higher pressures can cause can explosion.
(15) Never use oil, grease or any similar material on any apparatus or threaded fittings in the oxyacetylene or oxy-fuel gas system. Oil and grease in contact with oxygen will cause spontanteous combustion.
(16) Always use this correct sequence and technique for lighting a torch:
Open acetylene cylinder valve.
Open acetylene torch valve 1/4 turn.
Screw in acetylene regulator, adjusting valve handle to working pressure.
Turn off acetylene torch valve (you will have purged the acetylene line).
Slowly open oxygen cylinder valve all the way.
Open oxygen torch valve all the way.
Open oxygen torch torch valve 1/4 turn.
Screw in oxygen regulator screw to working pressure.
Turn off oxygen torch valve (you will have purged the oxygen line).
Open acetylene torch valve on 1/4 turn and light with a proper lighter.
Do not use matches or cigarette lighters.
Open oxygen torch valve 1/4 turn.
Adjust to proper flame.
(17) Always use this correct sequence and technique when shutting off a torch:
Close acetylene torch valve first, then close oxygen torch valve.
Close cylinder valves, acetylene valve first, then oxygen valve.
Open torch's acetylene and oxygen valves (this will release pressure in the regulator and hose).
Back off regulator adjusting valve handle until no spring tension is felt.
(18) Use adequate ventilation at the point of welding when welding lead, cadmium, chromium, manganese, brass, bronze, zinc, galvanized steel or other materials that an produce noxious gases.
(19) Make sure your arc welding equipment is installed and grounded properly and is in good working condition.
(20) Welding may produce fumes and gases hazardous to health. Avoid breathing these fumes. Use adequate ventilation.
(21) Nearly all gas welding fluxes and arc welding fluxes are toxic or at least can cause allergies to certain persons. Do not take welding fluxes internally and keep out of reach of children.
